Scanner Cautions - Colortrac SmartLF Ci40 Service Manual

6.

SCANNER CAUTIONS


Do:








Don't:














Notes:

Have 2 people to lift the scanner.
Keep the packaging for continued shipment of the scanner.
Normalise the scanner on first installation.
Auto-stitch the scanner on first installation and then when required.
Keep the auto-stitch and normalisation targets in a safe place for regular
use.
Use the approved and supplied cables for the scanner.
Read the operator and installation manual before installation.
Fill out and return the installation form as soon as possible.
Do not scan paper with any form metal fastener or post-it notes attached.
Do not allow the scanner to get wet.
Do not drop the scanner.
Do not stand the scanner on its end (packaged or un-packed).
Do not leave the scanner open for any length of time.
Do not stand on the scanner.
Do not balance the scanner on an unsafe surface.
Do not scan thick or rigid media.
Do not unplug the scanner during a scan sequence.
Do not let an end user remove any panels from the scanner.
Do not use any other power supply other than the approved one supplied
with the scanner.
Do not install the scanner on an un-even surface.
Do not install in a dusty or dirty environment.
Do not allow the USB / Ethernet cable to be pulled forcibly out of the
scanner.
Before any work is carried out on the
scanner, the power MUST be switched off
and the Mains Lead removed from the
scanner.
Most images in this manual are shown to be the Ci40 scanner, but the
Ci24 is to be treated in the same way as instructed, unless otherwise
stated. Some images may alternatively show the Ci24, but photos are for
reference only, and indicate the Ci scanners generally.
Some photos in this manual were taken during pre-production of the Ci
scanner, and some colours / background design shown may vary from the
actual scanner; however the instructions are still correct and should be
followed as described.
Ci Scanner Service Manual
NOTE:
Page 9