Table of Contents
Advertisement
Quick Links
CiIM
Issue 1
S
m
a
r
S
m
a
r
P
r
P
r
I
n
s
I
n
s
Colortrac Ltd
Ci Instruction Manual
This is a confidential controlled document and is the property of Colortrac Ltd.
It is not to be copied or reproduced in part or whole. It is intended for staff to read.
t
L
F
C
t
L
F
C
e
s
s
P
a
e
s
s
P
a
t
r
u
c
t
i
o
t
r
u
c
t
i
o
i
S
c
a
i
S
c
a
p
e
r
B
l
o
p
e
r
B
l
n
M
a
n
n
M
a
n
Page 1 of 8
Date: 02/09/10
n
n
e
r
n
n
e
r
c
k
o
c
k
u
a
l
u
a
l
s
s
Advertisement
Table of Contents
Related Manuals for Colortrac Ci24m
Summary of Contents for Colortrac Ci24m
- Page 1 Page 1 of 8 Issue 1 Date: 02/09/10 Ci Instruction Manual This is a confidential controlled document and is the property of Colortrac Ltd. It is not to be copied or reproduced in part or whole. It is intended for staff to read.
- Page 2 Colortrac Ltd makes every effort to ensure this publication is free from error. Misprints, errors • or quality observations should be reported to Technical Support, Colortrac Ltd. Colortrac Ltd shall not be liable for any damages, errors, issues or events that result from the • use of the equipment or this manual.
- Page 3 Ci Scanner Service Manual PRESS PAPER BLOCK Safety Precautions Ensure that the power is completely disconnected from the scanner unit. • Ensure the scanner is positioned on its Colortrac stand, or a stable maintenance platform. • Tools Medium Pozi-drive screwdriver •...
- Page 4 Ci Scanner Service Manual 3. Under the Mylar strip, remove the 4 x M4 Pan Head Screws from the elongated hole that screws on the Lid Cover Extrusion Sub-A. The second, adjacent screw adjusts the height of the lid (see instructions 9 -11).* NOTE: The Mylar strip should not be removed to get to the screws.
- Page 5 Ci Scanner Service Manual 6. Clean up the area of the missing Press Paper Block with a screwdriver, to remove any uneven surfaces. NOTE: If the block is still attached and is being replaced because of damage, use the screwdriver to break it off the Lid Cover Extrusion Sub-A before cleaning the surface.
- Page 6 Ci Scanner Service Manual 9. Position the Paper Press Block on to the adhesive and apply pressure for a few seconds to bond the Press Paper Block to the Lid Cover Extrusion Sub-A. Press Paper Blocks 10. Wipe off any excess adhesive from around the Press Paper Block using an clean dry tissue, and...
- Page 7 Ci Scanner Service Manual 12. Press the locking buttons and open the lid unit. 13. Replace the 4 x M4 Pan Head screws under the Mylar strip. Being careful not to damage the Mylar strip as you feed the screwdriver underneath it. 14.
- Page 8 Ci Scanner Service Manual 15. To raise the Lid Cover Extrusion Sub-A, loosen the 4 x holding screws (in the elongated holes). Then tighten the adjust screw next to it to push the lid further away from the lid unit. Tighten the holding screws again to lock the lid cover in place.
Need help?
Do you have a question about the Ci24m and is the answer not in the manual?
Questions and answers