Advertisement
SCIM-002
Issue 2
C
o
l
o
r
C
o
l
o
r
Colortrac Ltd
SC Instruction Manual
This is a confidential controlled document and is the property of Colortrac Ltd.
It is not to be copied or reproduced in part or whole.
t
r
a
c
S
t
r
a
c
S
S
e
n
s
o
S
e
n
s
o
C
S
c
a
C
S
c
a
r
G
l
a
s
r
G
l
a
s
Page 1 of 7
Date: 12/02/14
n
n
e
n
n
e
s
s
r
s
r
s
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Colortrac SmartLF SC25m
Summary of Contents for Colortrac SmartLF SC25m
- Page 1 SCIM-002 Colortrac Ltd Page 1 of 7 SC Instruction Manual Issue 2 Date: 12/02/14 This is a confidential controlled document and is the property of Colortrac Ltd. It is not to be copied or reproduced in part or whole.
-
Page 2: Instruction Manual
Technical Support, Colortrac Ltd. Colortrac Ltd shall not be liable for any damages, errors, issues or events that result from the use of the equipment or this manual. Page 2 of 7... - Page 3 SC Scanners Scanner Service Manual SingleSensor Glass Sub-Assy 1.1.1 Safety Precautions Ensure that the power and USB cables are completely disconnected from the scanner unit. Ensure the scanner is positioned on a stable maintenance platform. 1.1.2 Tools Medium Flat Screwdriver ...
- Page 4 SC Scanners Scanner Service Manual 3. Continue to gently pull the whole SingleSensor Glass Sub-Assy away from the Error! Reference source not found.. 4. Remove the SingleSensor Glass Sub-Assy 5. When refitting the SingleSensor Glass Sub- Assy, make sure the right end is against the End Plate.
- Page 5 SC Scanners Scanner Service Manual 7. Press firmly all along the SingleSensor Glass Sub- Assy until all the latches are locked in place. 8. Close the Error! Reference source not found.. 9. Reconnect the Power and USB cables to the Scanner and power up the scanner and Utilities Program.
- Page 6 SC Scanners Scanner Service Manual Calibration 1.3.1 Associated Part Numbers 10H028 : Calibration and Error! Reference source not found. Target 1. Open the Error! Reference source not found. and clean the SingleSensor Glass Sub-Assy with a soft cloth. Close the Lid Assembley.
- Page 7 SC Scanners Scanner Service Manual 5. Click ‘OK’ to except the message. 6. After approx. 4 minutes, the ‘Calibration’ (or Normalisation) is complete. During calibration , the target will move through the scanner in stages several times. Page 7 of 7...
Need help?
Do you have a question about the SmartLF SC25m and is the answer not in the manual?
Questions and answers