Installing The Gs970Emx/10 Switch; Figure 17: Placing The Gs970Emx/10 Switch Upside Down On A Table - Allied Telesis GS970EMX/10 Installation Manual

Installing the GS970EMX/10 Switch

This section contains instructions for installing the GS970EMX/10 switch in
a standard 19-inch equipment rack with the optional RKMT-J05 equipment
rack brackets kit. Here are the required items:
 One RKMT-J05 rack mount brackets kit (sold separately)
 Phillips-head screwdriver (not provided)
 Four standard equipment rack screws (not provided)
If the bumper feet are installed on the bottom panel of the switch, perform
steps 1 and 2 to remove them. Otherwise, start with step 3.
To install the switch in a 19-inch equipment rack with the RKMT-J05
equipment rack brackets kit, perform the following procedure:
1. Place the GS970EMX/10 switch upside down on a table or desk. Refer
to Figure 17.
Figure 17. Placing the GS970EMX/10 Switch Upside Down on a Table
GS970EMX/10 Gigabit Ethernet Switch Installation Guide
53