Marking Field And Marking Center Position - Panasonic LP-M Series Maintenance Manual

2-3-5 Marking field and marking center position

Specified point LP-M200
A : Work distance
(Base level)
B : Work distance
variable length
*1
C : Marking field
(X, Y) *1
*1 : For LP-MA00/LP-MA05/LP-MA06 type depending on the material and shape of the work-piece and setting details, the
available range might be limited due to the risk of the reflected laser beam. Confirm the available setting range by the
application test before the introduction of the marking system. Please contact our sales office for details.
Unit: mm
• Do not place anything in the area between the laser emission port and lasing object during the marking operation.
• Use anti-reflection material (ex. black paint for metal) for an external shutter or a protective enclosure in a path of laser
beam. It may cause a failure of the components inside the laser marker head.
• If any other devices such as a sensor or a camera are installed near the laser marker, make sure that these devices are
installed in the place where laser beam and its reflected beam do not damage to them.
• The work distance setting by the software should conform with the actual distance from the head base to the marking
surface for the proper marking performance.
LP-M500 LP-MA00
190 mm
120 mm × 120 mm
56
135
B
C
LP-M505 LP-M205
220 mm
-22 mm to +22 mm
220 mm × 220 mm
103
Marking center
C
ME-LPM-SSM-10
LP-MA05 LP-MA06
330 mm
330 mm × 330 mm
A
55