Panasonic LP-M Series Maintenance Manual page 89

Terminal No. Name / Description
Data number for Rank /External offset function (SELECT 0 input: ON)
t
The rank/external offset function is a function that switches marking characters (rank) or the
coordinates (external offset) using the input terminal D0 to D15. Configure the character or coordinate
patterns to the data number corresponding to D0 to D15 in advance. Specify which pattern you will
mark from D0 to D15.
Specify the data number in the binary system as D0 to D15 and turn ON the set input.
The data numbers corresponding to D0 to D15 are defined as follows according to the settings.
I/O input condition settings *
Rank: 4-bit × 4
Rank: 8-bit × 2
External offset: Lower 4 bits
External offset: Lower 8 bits
External offset: Lower 10 bits
* You can also use the rank function together with the external offset function. If you use the same
terminal for both the rank and external offset at this time, the input status will be reflected to the
data number of both functions.
Example: Specify data number 15 when using lower 8 bits
Select "0000 1111", which represents 15 in a 8-bit binary system, by specifying ON/OFF of D0 to D7
as shown in the below table. (D0 is the lowest digit number.)
D0 to D7: Data number (the lower 8 bits are used)
Terminal
D0
D1
D2
D3
D4
D5
D6
D7
19 RESERVE: System reservation
Do not connect externally.
Terminal
D0 to D3
D4 to D7
D8 to D11
D12 to D15
D0 to D7
D8 to D15
D0 to D3
D0 to D7
D0 to D9
Data number (binary)
1
1
1
1
0
0
0
0
ME-LPM-SSM-10
Data number target
Rank 0
Rank 1
Rank 2
Rank 3
Rank 0
Rank 1
External Offset
External Offset
External Offset
INPUT
ON
ON
ON
ON
OFF
OFF
OFF
OFF
Data number
0 to 15
0 to 15
0 to 15
0 to 15
0 to 255
0 to 255
0 to 15
0 to 255
0 to 1023
89