Panasonic LP-M Series Maintenance Manual page 44

„ Rear
2
1
7
12
13
14
15
16
LP-M200/M205/M500/M505
1. USB connector A (2 connectors)
This is the terminal for connecting the USB media or USB mouse.
For registering or saving data in the laser marker, connect a commercially available USB.
You can also connect a USB mouse when setting by using a commercially available monitor.
A USB port is also mounted on the front.
• Do not connect the USB devices other than a USB media or a USB mouse.
2. VGA connector: VGA OUT
This is the connector for connecting VGA OUT monitor. When using a separately sold console, connect the attached
return harness.
3. Ethernet port
This is the connector for connecting to the external device to control the laser marker with Ethernet. For details, refer
to Serial Communication Guide.
4. Return connector: RETURN OUT
5. Console return connector: (VGA+RETURN) IN
Connectors for connecting the attached return harness for using console (option).
6. RS-232C connector: RS-232C
This is the connector for connecting to the external device so as to control the laser marker with RS-232C. For details,
refer to Serial Communication Guide.
7. Signal connector: SIGNAL
This is the terminal for communicating between head and controller. Connect the attached signal cable.
8. DIP switch
Sets the operational options of the laser marker. For details, refer to "2-2-3 DIP switch" (P.46).
• A plastic cover is installed on the DIP switch. Install this cover always to avoid the dust penetration to the controller.
44
3
4
2
5
1
6
7
8
16
9
10
14
11
15
17
12
18
21
22
24
25
23
20
19
ME-LPM-SSM-10
LP-MA00/MA05/MA06
3
4
5
6
8
9
10
11
13
17
18
21
22
24
25
23
20
19