Installation Method - Panasonic LP-M Series Maintenance Manual

2-3-2 Installation method

• Check the length of the screw and install it. Using improper screws and
forcibly tightening them might damage the product.
„ Head
• Install the head on a plate with a thickness of 10 mm to 15 mm which
is made of aluminum or other material with radiation performance
equivalent to that of aluminum.
• The head can be fixed from the bottom with M6 screw at six locations.
• For the installation dimension, refer to "1-4-1 Head" (P.33).
• The inserting length of the screw into the head shall be 5 mm to 7 mm
as shown by the figure below.
• Tightening torque: 3.0 N·m or less.
• For LP-MA00, depending on the position of the air nozzle, provide the counterboring shape in the trough-holes of the
head installation plate to avoid the interference between the air nozzle and the screws for the head fixing.
Laser marker head
Installation plate
„ Example of head installation plate
Example dimensions of plate for the head are indicated below.
For plate thickness of 10 mm
Unit: mm
q 30
e 80
93
No. Description
Head fixing hole (six holes): φ6.6 through hole, for LP-MA00 with a counterbore of φ13 and depth 8.5 *1
q
Head positioning pin (2 pins): φ4, SUS pin, height 5
w
Air nozzle fixing hole for LP-MA00 (two holes for front *2): M6 through hole
e
Air nozzle fixing hole for LP-MA00 (two holes for rear *2): M6 through hole
r
Air nozzle fixing hole for LP-MA00 (two holes for each side *2): M6 through hole
t
*1 : The counterbore is required only for LP-MA00 in case the head fixing screws interfere with the air nozzle.
*2 : Required only for LP-MA00 type. Install the air nozzle to either side around the laser emission port. Refer to "Installation
of air nozzle and removing dust by compressed air" (P.50).
• As the laser pointer radiate the beam toward the center of the marking field, it is recommended to process the laser
emission port and laser pointer emission port hole to link them so that the laser pointer's beam path does not interfere
with the plate.
Plate with a counterbore (LP-MA00)
A
B
M6 screw
55
40 40 t 90
80 80 r
93
A
C
A : Screw insert length 5 mm to 7 mm
B : Plate thickness + washer thickness
C : (Plate thickness - depth of counterbore) + washer thickness
10 5 w
On the laser marker side
ME-LPM-SSM-10
M6 screw
60 60
49