Connecting The User System - Renesas Single-Chip Microcomputer M306NKT3 User Manual

M306NKT3-RPD-E User's Manual

2.8 Connecting the User System

Connect the emulation pod to the user system for M16C/6N4 or M16C/6N5. and for M16C/6NK, M16C/6NL, M16C/6NM
and M16C/6NN as shown in Figures 2.8 and 2.9, respectively.
0.65mm pitch
M3T-F160-100NRB LCCソケット
100-pin QFP 100-pin LCC
(not included) (included)
Figure 2.8 Connecting the user system (for M16C/6N4 or M16C/6N5)
Note on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulation
pod.
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006
Tip of emulation pod probe
M30800T-PTC
(included)
M3T-FLX100-T
(not included )
M3T-DIRECT100S
100-pin QFP
(not included)
●
: No. 1 pin
*1: These three items are included in one package .
CAUTION
100-pin
M3T-100LCC-DMS
(not included)
M3T-FLX100-R
(not included)
*1
M3T-DUMMY100S
M3T-F160-100NSD
100-pin QFP 100-pin LQFP
(not included) (not included)
2. Setup
0.5mm pitch
M30800T-PTC
(included)
M3T-100LCC-QSD
100-pin LQFP
(not included)
Page 30 of 104