Connecting The Emulator To The User System - Renesas E1 User Manual

E1/E20 Emulator

2.3. Connecting the Emulator to the User System

Use the procedure below to connect the emulator to the user system with the user-system interface cable, or to
disconnect them when moving the emulator or the user system.
(1) Connect the user-system interface cable to the user-side connector of the emulator.
When connecting the user-system interface cable to the E1 emulator, check the position of the erroneous
insertion prevention key to ensure that the cable is plugged in correctly.
When connecting the user-system interface cable to the E20 emulator, check to see that the cable is plugged in
correctly, with the TOP side of its connector cover up.
User-side connector
Figure 2.2 User-Side Connector on the E1 and E20
Notes on connector insertion and removal:
When connecting or disconnecting the user-system interface cable and the emulator or user system,
grasp the connector cover at the end of the cable. Pulling the cable itself will damage the wiring.
Also, be aware that the user-system interface cable has the direction in which it must be inserted. If
the cable is connected in the wrong direction, it may break down.
R20UT0398EJ0401 Rev.4.01
Mar 15, 2016
USER I/F
E1 Emulator
Correct example
User-side connector
E20 Emulator
CAUTION
USER I/F
Incorrect example
Page 19 of 40
Setup