Table of Contents
Advertisement
E2, IE850A
2.Connecting the Emulator and User System
2.1
Connector
To connect the emulator to a user system, a connector must be mounted on the system. The 14-pin connector
and 34-pin connector can be used for external tracing. Mount the 34-pin connector if you intend to use
external tracing. Table 2-1 shows the two types of connector and supported emulators.
Table 2-1
Connectors and Supported Emulators
14-pin connector
34-pin connector
Connector
for external tracing
2.1.1
14-pin connector
Table 2-2 shows the recommended connectors for connection of the E2 emulator. When other components
are mounted around the connector, do not mount components with heights exceeding 10 mm within 5 mm of
the connector on the user system as shown in Figure 2-1.
When designing the user system that mounts the 14-pin connector, refer to this section in this manual and the
user's manual for the target device.
Table 2-2
Recommended 14-pin Connectors
7614-6002
14-pin
connector
2514-6002
Figure 2-1
R20UT4140EJ0300 Rev.3.00
Oct.09.20
Connectable.
Connectable via a 34-pin to 14-pin
conversion adapter (however,
external tracing is not available).
Type Number
Manufacturer
3M Japan Limited
3M Limited
5 mm
2
1
5 mm
5 mm
Area where restriction applies to mounted components
(components must have heights no greater than 10 mm)
Area where Restriction Applies to Mounted Components
2. Connecting the Emulator and User System
Supported Emulator
E2
14-pin straight type (Japan)
14-pin straight type (other countries)
Top View
4
6
8
10
12
14
3
5
7
9
11
13
5 mm
IE850A
Not connectable.
Can be connected.
Specification
Page 5 of 41
Advertisement
Table of Contents
