Connecting The Pc4701; Connecting The Cable To The Pc4701 - Renesas Single-Chip Microcomputer M306NKT3 User Manual

Emulation pod for m16c/6n group m16c/6n4, 6n5, 6nk, 6nl, 6nm and 6nn

Table of Contents

M306NKT3-RPD-E User's Manual

2.4 Connecting the PC4701

To connect the emulation pod to the PC4701, use the FLX120-RPD 120-pin flexible cable included with this product package.

Connect the PC4701 side connector of the FLX120-RPD to the cable connector of the PC4701, then secure with screws the

FLX120-RPD.

Figure 2.2 shows how to connect the PC4701 and FLX120-RPD.

Figure 2.2 Connecting the cable to the PC4701

Note on Connecting the PC4701 and FLX120-RPD:

Always shut OFF power before connecting the cable. Otherwise, the internal circuits may be damaged.

Notes on Connecting the Cable and Securing the Screws:

To connect the FLX120-RPD, be sure to hold the both sides of the PC4701 side connector horizontally with the

"UPSIDE" facing up.

After connecting the cable to the emulator main unit PC4701, be sure to secure the screws mounted in both

sides of the connector.

REJ10J0326-0400 Rev.4.00 Sep. 01, 2006

Emulator main unit

Secure this screw.

CAUTION

IMPORTANT

PC4701 side connector

of FLX120-RPD

UPSIDE should be face up .

Secure this screw.

2. Setup

Page 23 of 104

Table of Contents

M306nkt3-rpd-e