Renesas Single-Chip Microcomputer M306NKT3 User Manual page 48

M306NKT3-RPD-E User's Manual
Table 2.4 Switch settings of the M306NKT3-RPD-E (2)
Signal Switch
Xout SW3
P86/Xcout SW4
P87/Xcin SW5
Note on Switch Settings:
Always shut OFF power before changing switch setting.
Note on BYTE and CNVss Switch Settings:
Switch settings of the BYTE and CNVss are for debugging without the user system connected.
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006
Setting
SW3
Does not connect pin Xout of the MCU to the user system.
(factory-settings)
SW3
Connects pin Xout of the MCU to the user system.
Connects pin P86/Xcout of the MCU to the user system to use it as
port P86 or Xcout.
SW4
(factory-settings)
Does not connect pin P86/Xcout of the MCU to the user system.
SW4
Connects pin P87/Xcin of the MCU as port P87.
SW5
(factory-settings)
Connects pin P87/Xcin of the MCU as Xcin.
SW5
CAUTION
IMPORTANT
Description
Page 46 of 104
2. Setup