Table of Contents
Advertisement
M306NKT3-RPD-E User's Manual
2.8.7 Connecting to a 128-pin 0.5mm pitch Foot Pattern
Figure 2.16 shows how to connect a 128-pin 0.5mm pitch foot pattern on the user system to the M3T-F160-128NRD (not
included), and here following is its procedure.
For details on the M3T-F160-128NRD (not included), refer to its user's manual.
(1) Attach the NQPACK128RD included with the M3T-F160-128NRD to the user system.
(2) Attach the YQPACK128RD included with M3T-F160-128NRD to the NQPACK128RD and secure it with the
YQ-GUIDE's.
(3) Attach the CN2 side of the M3T-F160-128NRD to the CN2 side of the package converter board connected to the emulation
pod probe.
(4) Attach the M3T-F160-128NRD to the YQPACK128RD.
These corners are not round.
*: These four items are available in one package.
Figure 2.16 Connecting to a 128-pin 0.65mm pitch foot pattern
Note on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulation
pod.
The connectors of the M3T-F160-128NRD are guaranteed for only 50 insertion/removal iterations.
REJ10J0326-0400 Rev.4.00 Sep. 01, 2006
Tip of emulation pod probe
Package converter board
CN2 side
③
④
YQ-GUIDE (x4)
*
YQPACK128RD
②
NQPACK128RD
(PLQP0128KB-A) foot pattern
①
No. 1 pin
CAUTION
M3T-F160-128NRD
(not included)
On-board evaluation
HQPACK128RD
(not included)
FLASH MCU, etc.
128-pin 0.5mm pitch
User system
2. Setup
Page 38 of 104
Advertisement
Table of Contents
