Serial Port Input Connections - FreeFlight 2101 I/O Approach Plus Installation And Checkout Manual

FreeFlight 2101 I/O Approach Plus Serial Port Input Connections
FreeFlight 2101 FreeFlight 2101
SIGNAL I/O Approach
NAME Plus
SERIAL PORT 1 SERIAL PORT 2
RXD+ J1-7
RXD- J1-8
CABLE J1-3,20
SHIELD
SETUP -
FreeFlight P/N 12480-00 - RS-232 Adapter Input Connections for use with Port 1 and Port 2
FreeFlight 2101
SIGNAL I/O Approach
NAME Plus
SERIAL PORT 1 SERIAL PORT 2
RXD+ J1-7
RXD- J1-8
SERIAL J1-1
COMMON
CABLE J1-3,20
SHIELD
AIRCRAFT
POWER J1-16,17
NOTE 3
AIRCRAFT
GROUND J1-3,20
NOTE 3
SETUP -
Revision E
May 31, 2006
ROSETTA ROSETTA
I/O Approach SERIALIZER ENCODER ENCODER
Plus ARS 50 ARS 100 NOTE 4
NOTE 4, 5 NOTE 4
J1-24 15 15
J1-36 7 7
J1-3,20 15 15
- ENCODER ENCODER
FreeFlight 2101
RS-422/232 ADAPTER
I/O Approach FREEFLIGHT 12480-00
Plus
RS-422 SIDE RS-232 SIDE
J1-24 14 -
J1-36 2 2
J1-1
- 7
J1-3,20 7 7
J1-16,17 25 -
J1-3,20
7 -
- - -
Consult all relevant Installation Manuals before wiring!!!
Figure 2-12 Serial Port Input Connections
RMI ICARUS SHADIN PC SERIAL
3000 AIRDATA PORT
NOTE 4,5 ADC 200 (25 PIN D)
NOTE 4,6 NOTE 2
1 7 11 7
6 2 12 2
1 15 9 1
RMI ENCODER ENCODER ENCODER
PC SERIAL PC SERIAL
PORT PORT
(25 PIN D) 9 PIN D)
NOTE 2 NOTE 2
7 5
2 3
7 5
1 5
- -
- -
(ANY) (ANY)
CAUTION
FreeFlight 2101 I/O Approach Plus GPS Navigation System
PC SERIAL
PORT
(9 PIN D)
NOTE 2
5
3
5
ENCODER
Notes:
1. Should be configured for RS-422 communications.
2. The recommended connection is to use a FreeFlight P/N 12480-
00 RS-422/232 adapter. However, a direct connection will work in
most installations. See Appendix B for further details on the serial
data interface.
3. Power and ground connections are shown only for FreeFlight
products and adapters.
4. Most encoders require approximately 10 minutes to warm-up.
The data output before this period has expired may be in error
and should not be used. Refer to the appropriate equipment's
manual for more specific information.
5. Serializer connects to the aircraft's existing Mode C encoder and
provides the FreeFlight GPS receiver with serial altitude
information. A serializer is required for blind encoders and
devices with Gray Code outputs.
6. Do not use heading input from the ADC-200 when interfacing
synchro inputs.
Page 2-27/28