Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
ENG
6.6.4 Selection of the Linear and Rotary Unit System
In step 4 of the Motor Wizard the GUI (Graphical User Interface) of the LinMot-Talk software can be set. This
setting only affects the display of the LinMot-Talk software. The resolution and scaling of the transmission
data (raw data) to the higher-level PLC are retained.
Figure: Selection of the units to be displayed in the LinMot-Talk software
6.6.5 Referencing the Linear Motor
The built-in linear motor has a position detection system which must be referenced. Various modes are
available to the user for this purpose. Depending on the selected mode, the linear motor searches for a
mechanical stop and/or an electronic switch, for example.
Figure: Selection of reference run linear motor
Page 20 / 34
PR02-88
NTI AG / LinMot
Advertisement
Table of Contents
