Table of Contents
Advertisement
7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
4.1.
SYTEM TAB
Card Mode Control
Card Mode: This monitor displays the behavior of the module.
Firmware Version
Firmware Version: This monitor displays the current firmware version.
Note: For IP address settings on Control and Data ports, after applying any changes,
the device must be rebooted for the changes to take. Reboot can be pressed at the
bottom of this System tab after all changes are made.
Control Port
IP Address: This control allows the user to set the IP address on the Control Port. This control will
also display the currently set IP address.
Netmask: This control allows the user to set the Netmask for the Control Port IP address. This control
will also display the currently set Netmask.
Gateway: This control allows the user to set the Gateway for the Control Port. This control will also
display the currently set Gateway address.
Page - 12
Figure 4-2 : WebEASY
Revision 1.0
– System Tab Part 1
®
Advertisement
Table of Contents
