Decoder Audio Control Tab; Decoder Audio Control Tab; Figure 4-7 : Webeasy - evertz 7882J2KX-IPASI User Manual

7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
IGMPV3 SSM Profile Control
For Main and Backup
IGMP Source 1 to 6: The user can add the required SSM sources for V3.
Switch Over Control
User Redundancy Mode: This control is used to enable redundancy mode for switch over on a loss
input. When redundancy mode is enabled, Main will be the primary source input for the decoder.
Decoder Source: This monitor displays the Decoder source used for the output.
Manual Profile Select (when redundancy disabled): This control is used to manually select which
input profile to use. Options are Main or Backup.
Wait Switch Time after Loss of Primary Input: This control is used to set the amount of time in
seconds on a loss signal of the primary input before switching over to the Backup feed.
Wait Switch Time after Loss of Backup Input: This control is used to set the amount of time in
seconds on a loss signal of the backup input before switching over to the Main feed.
4.4.

DECODER AUDIO CONTROL TAB

Figure 4-7 : WebEASY

– Decoder Audio Control Tab

®
Audio Input Control
For Audio 1-4:
PID Select: This control is used to select the audio PID to use for decoding.
Audio Delay: This control is used to set an audio delay in ms.
Page - 19
Revision 1.0