Figure 5-10 : Vistalink; Encoders Control Tab Part 2 - evertz 7882J2KX-IPASI User Manual

7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
Main IP Output Stream State: This parameter allows the user to enable or disable streaming out of
the device. When this control is configured to disabled, the IP output will stop.
Backup IP Output Stream State: This parameter enables or disables SFP 2 to be used for back up.
Backup IP Address (SFP 2): This parameter allows the user to select a streaming output IP address
for the Contribution Backup Encoder. Can be a Multicast or Unicast address.
Backup UDP Port Number (SFP 2): This parameter allows the user to select the destination UDP port
number of the backup streaming output.
Video Control
Encoder SDI Input: This control selects the SDI input to use for encoding.
Encoder Controls Basic
PMT PID: This parameter allows the user to select the PMT PID number of the output stream.
Video PID: This parameter allows the user to select the Video PID number of the output stream.
PCR PID: This parameter allows the user to select the PCR PID number of the output stream.
Encoder Controls Advanced
VANC PID: This parameter allows the user to select the VANC PID number of the output stream.
VANC PID Enable Disable: This parameter allows the user to enable or disable the VANC PID number
of the output stream.
Max Bitrate: This parameter allows the user to set the maximum bitrate for the VANC data on the
output stream in Kbps. Range is 0 to 400 Kbps.

Figure 5-10 : VistaLINK

- Encoders Control Tab Part 2

®
Audio PID Assignment
Audio 1 to 4 PID: The 7882J2KX-IPASI has 4 x Audio Pids. These parameters allow the user to select
the Audio PID number.
Page - 45
Revision 1.0