Table of Contents
Advertisement
7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
Figure 5-2 : VistaLINK
- System Tab Part 2
®
SNMP Trap Destinations
There are 10 trap destinations that can be configured and enabled.
Destination Enable: This control is used to enable or disable sending out traps.
Destination IP Address: This control is used to specify the trap IP address.
BNC
BNC Output 1-4: This parameter allows the user to select the BNC output type. Available options are
V-Proc HD/SD-SDI Loopout (forwards the currently selected input), J2K ASI and Decoder.
System Control
Reboot: This control can be used to soft reboot the device. It will cycle the power relay and cause an
effective power cycle.
Page - 34
Revision 1.0
Advertisement
Table of Contents
