Figure 5-5 : Vistalink; Decoder Control Tab (Part 2) - evertz 7882J2KX-IPASI User Manual

IGMPV3 SSM Profile Control
For Main and Backup:
IGMP Source 1 to 6: The user can add the required SSM sources for V3.
Switch Over Control
User Redundancy Mode: This control is used to enable redundancy mode for switch over on a loss
input. When redundancy mode is enabled, Main will be the primary source input for the decoder.
Decoder Source: This monitor displays the Decoder source used for the output.
Manual Profile Select (when redundancy disabled): This control is used to manually select which
input profile to use. Options are Main or Backup.
Wait Switch Time after Loss of Primary Input: This control is used to set the amount of time in
seconds on a loss signal of the primary input before switching over to the Backup feed.
Wait Switch Time after Loss of Backup Input: This control is used to set the amount of time in
seconds on a loss signal of the backup input before switching over to the Main feed.

Figure 5-5 : VistaLINK

Single Channel J2K Encoder/Decoder

- Decoder Control Tab (Part 2)

®
Revision 1.0
7882J2KX-IPASI
Page - 39