Table of Contents
Advertisement
7882J2KX-IPASI
Single Channel J2K Encoder/Decoder
3.3.
HARDWARE INSTALLATION
3.3.1. Three Different Ways to Control and Configure the 7882J2KX-IPASI
There are three different ways that 7882J2KX-IPASI can be controlled and configured.
1. WebEASY
using the Control Port on the 7882J2KX-IPASI.
®
2. VistaLINK
using the Control Port on the 7882J2KX-IPASI.
®
3. VistaLINK
using the 7800FC (frame controller) with 7882J2KX-IPASI installed in frame.
®
When using the Control Port on the 7882J2KX-IPASI, each module will need to be assigned to an IP
address in order to communicate. When using a frame controller, multiple cards can be inserted in the
frame and be controlled using only one IP address of the frame controller.
3.3.2. Module Installation
Before handling the card it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn.
Locate on a frame chassis two adjacent vacant slots. Unpack the 7882J2KX-IPASI and separate the
rear plate module from the main card. Locate on the rear of the rack the two slots and remove the
blanking panels. Insert the rear plate module into the back of the chassis and secure using the four
screws provided.
Insert the 7882J2KX-IPASI card into the corresponding front slots ensuring the card lines up with the
slot runners on the bottom and the top of the chassis. Push the card into the slot ensuring that when it
mates with the rear card that is has been firmly pushed into a seated position. This can be confirmed
when the connectivity lights for the Ethernet port are illuminated by connecting the module's Ethernet
port to an active port of a computer using an Ethernet cable then remove.
Do not connect any cables to the rear card (failure to do this could cause unwanted network issues)
until the initial configuration has been completed.
Page - 8
Figure 3-3 : 7800 Chassis
Revision 1.0
Advertisement
Table of Contents
