Name Of Each Part Of Emulator - Renesas Compact Emulator M30620T-CPE User Manual

(2) Name of Each Part of Emulator

Figure 2.2 shows the name of each part of the emulator.
P8 /X selection switch
7 CIN
(Factory-setting: PORT)
J2: Serial interface cable
connector
J1: Power connector
System status LED
LED1: State of power of emulator
Figure 2.2 Name of each part of emulator (upper side of M30620T-CPE)
(1) System status LED
The system status LED indicates the emulator main unit's power supply. Table 2.1 lists the
definition of system status LED.
Table 2.1 Definition of system status LED
Name Number
POWER LED1
(2) Target status LED
The target status LEDs indicate the target MCU's power supply and operating status. Table 2.2
lists the definition of each target status LED.
Table 2.2 Definition of target status LEDs
Name Number
POWER LED2
CLOCK LED3
RESET LED4
RUN LED5
Target status LED
LED2: Power of target system (POWER)
LED3: Oscillation of XIN/XCIN (CLOCK)
LED4: Reset pin of MCU (RESET)
LED5: Execution of program (RUN)
Color Status
Orange ON Emulator power supply is turned on.
OFF Emulator power supply is turned off.
Color Status
Orange ON Power is supplied from the target MCU.
OFF Power is not supplied from the target MCU.
Green ON Clock X
OFF Clock is not supplied to the target MCU.
Red ON Target MCU is reset.
OFF Target MCU is not reset.
Green ON User program is being executed.
OFF User program has been halted.
( 17 / 52 )
System reset switch
J1: MCU power supply selection jumper
(Factory-setting: INT)
Function
Function
or X is supplied to the target MCU.
IN CIN