Name Of Each Part Of Emulator - Renesas M30800T-CPE User Manual

(2) Name of Each Part of Emulator

Figure 2.2 shows the name of each part of the emulator.
P8 /X select switch
7 CIN
(Factory-setting: P87)
System reset switch
J2: Serial interface cable
connector
J1: Power connector
System status LEDs
LED1: Power of emulator
(POWER)
LED2: Starting-up of emulator
(SAFE)
Figure 2.2 Name of each part of emulator (top view of M30800T-CPE)
(1) System status LEDs
The system status LEDs indicate the emulator main unit's power supply. Table 2.1 lists the
definition of system status LED.
Table 2.1 Definition of system status LED
Name Number
POWER LED1
SAFE LED2
(2) Target status LEDs
The target status LEDs indicate the target MCU's power supply and operating status. Table 2.2
lists the definition of each target status LED.
Table 2.2 Definition of target status LEDs
Name Number
POWER LED2
CLOCK LED3
RESET LED4
RUN LED5
Target status LEDs
LED3: Power of target system (POWER)
LED4: Oscillation of clock (CLOCK)
LED5: Reset pin of MCU (RESET)
LED6: Execution of program (RUN)
Color Status
Orange ON Power is supplied to the emulator.
OFF Power is not supplied to the emulator.
Green ON Emulator started up normally.
OFF Emulator did not start up normally.
Color Status
Orange ON Power is supplied to the target MCU.
OFF Power is not supplied to the target MCU.
Green ON BCLK is output from the target MCU.
OFF BCLK is not output from the target MCU.
Red ON Target MCU is being reset.
OFF Target MCU is not being reset.
Green ON User program is being executed.
OFF User program has been halted.
( 19 / 52 )
JP1: MCU power supply select jumper
(Factory-setting: INT)
JP2: MCU power voltage select jumper
(Fixed to 5.0 V)
Function
Function