Switching Tones On And Off; Service; Device Info; Measurement Menu Setting - sauter FS Series Manual

11.1.5 Switching tones on and off

Menu Unit→ settings Switch tones→ on and off

11.1.6 Service

Menu Unit Settings→ Service→
11.1.6.1 Display raw data
Switch here to display the raw measured values during adjustment as AD value or as
voltage in mV.
11.1.6.2 Reset unit
Do not use this function! Contact the service department!

11.1.7 Device info

Menu Device Settings→ Device Info→
Here they receive information about
- Device name or model
- Installed firmware revision
- Serial number of the unit

11.2 Measurement menu Setting

11.2.1 Measuring frequency

11.2.1.1 Setting
By clicking on change, you can change the frequency with which the measured values
are stored in the "Track" mode or transmitted to the interface! The following frequencies
are possible: 1000, 500, 100, 50, 10, 5 and 1 Hz.
11.2.1.2 What frequency is needed?
Choose the frequency as low as possible and as high as necessary! High frequency
data storage or transmission causes a large amount of data which takes a long time to
transmit.
11.2.1.2.1 For long-term measurements
such as a fatigue test, select a very low frequency, max. 50Hz.
18 FS-BA-en-2210.docx