Accessories; Standard Accessories For Force Gauges With Internal Measuring Cell; External Measuring Cells - sauter FS Series Manual

Table of Contents

13 Accessories

When attaching accessories to your sensor, please note that the dead weight

of the accessories must be taken into account!

13.1

measuring cell

• AC 43 Standard Attachments Metal

• AE 01 Standard clamp Clamping range from 0 to 7 mm, 0 to 500 N

• AE 02 Wide jaw clamp Clamping range from 0 to 6 mm, 0 to 500 N

• AE 03 Strap tension clamp Clamping width from 0 to 2.5 mm, 0 to 500 N

• AE 04 Strap tension clamp Clamping width from 0 to 6 mm, 0 to 500 N

• AE 05 Rope and thread tension clamp 0 to 500 N

• AE 06 Cable pull-off clamp Clamping width 1.5 to 6 mm, 0 to 500 N

• AE 07 Wedge clamp Clamping width 0 to 6 mm, 0 to 500 N

• AE 2K screw clamp Clamping width 0 to 15 mm, 0 to 2000 N

• AE 500 Screw clamp Clamping range from 0 to 10 mm, 0 to 500 N

• AFK 02 Holder for force gauges

Further accessories can be found in the webshop

External sensors are available in the webshop www.sauter.eu. For each sensor you

need the service corresponding to the nominal load from the following table, incl.

connector and memory chip:

FS-BA-en-2210.docx

Standard accessories for force gauges with internal

www.sauter.eu

Table of Contents

Fs 2 Fs 2-20 Fs 2-50 Fs 2-100 Fs 2-200 Fs 2-500 ... Show all