Start Measurement; Initialise Measuring Channels; Tare Measuring Channels; Channel Single - sauter FS Series Manual

10.2 Start measurement

Click on Measurement on the touch screen

10.3 Initialise measuring channels

Press the START/STOP button to display the measured values of the connected
sensors.

10.4 Tare measuring channels

10.4.1 Channel single

To set a single channel to zero, click with the touch pen on →0"" to the right of the
displayed channel.

10.4.2 Set all channels to zero (tare)

Press and hold the button for at least →03 seconds to set all connected sensors to
0.

10.5 Save measurement data

The different measuring functions that you can use and how the measured values are
stored is described in section 11.2.3

10.6 Force direction

Units with internal sensor can measure forces in tension direction (positive measured
value) and in compression direction (negative measured value). External sensors can
differ. You can use sensors for tensile and compressive force or tensile force sensors
or compressive force sensors. For more information on external sensors, see chapter
13.2 External measuring cells.
14 FS-BA-en-2210.docx