Readability - sauter FS Series Manual

11.2.1.2.2 For short time measurements
Such as maximum load measurement to destruction, which lasts only a few seconds
choose a higher frequency.

11.2.2 Readability

By clicking on change you can increase the readability by the displayed factor. The
maximum resolution is n=10,000
The smallest adjustable readability for a sensor is calculated as follows:
Example FS 2-100:
Set the readability factor as high as possible and as low as necessary! Very low
readability often leads to unstable display values with the measuring technology used
and the high sampling frequencies. Readability factor 1 should only be set if the
measured data is subsequently processed with additional PC programs, for example
to filter, smooth, etc. the stored values.
If values are only read or stored manually, it is recommended to set the readability
factor ≥ 5.
FS-BA-en-2210.docx
�� : ���������������� ������������������������ ���� ��
������
������: ���������������� ���� ��
��: ���������������� ��������ö��������
��: ������������������������ ������������������������ ���� ��
��������: ��������������������������������������
�� =
������
�� = �� ∗ �������� =
������
������ = 100 ��
100��
�� =
������
10.000
�������� = 2
������
�� = ∗ �������� =
��
������
��
������
∗ ��������
��
= 0,01��
100��
∗ 2 = 0,02��
10.000
19