Measurement Practice - sauter FL series Instruction Manual

The FL-series have an analog output +/- 2V,
In normal operation use analog values depend on the reading value of TRACK,
PEAKT and PEAKC mode. If PASS-FAIL function is used analog value = 2V when
PASS, and analog value = 0V when FAIL.
7) ABOUT
This shows the information of your gauge (Firmware revision, Model, Capacity, Serial
number). To access ABOUT menu, go to main menu page and press UP and DOWN
to move the cursor point to ABOUT and press ENTER key the display will show
About menu page. Press ESC key to return to main menu page.
Figure 9 About Menu

10 Measurement Practice

For best measurement accuracy, keep the compression/tension forces in line with
the force gauge. Alleviate bending loads and torque loads applied to the load cell as
these can adversely affect measurement performance.
Always keep the gauge below the capacity limit shown on the front of the gauge. If
the gauge is used above this capacity in either tension or compression, even for a
short time, permanent load cell damage can result. An overload damage will not be
covered by warranty.
11 Detailed technical description of FL
Accuracy: ± 0.2 % of rated capacity
Operating temperature: 60 ºF - 95 ºF (15 ºC - 35 ºC)
Temperature shift at zero load: ± 0.04 % of full-scale/ºC
12 FL-BA-e-1714