Advertisement
Environment and Product Type
5.2
Environment Settings (Environment settings common for all types)
5.2.7
Save Image Mode
Allows you to set up how images are saved. The maximum number of images that can
be stored is 8. If you select Continuity, Trap, or Lim. Cond. as the save mode, you can
select Overwrite: Yes or No for the saved image memory for all of the save modes.
− Manual
Image is held using the keypad.
− Continuity
Stores the image for every inspection.
− Trap
Saves the image when the result in the register set for Trap in Judgment is NG
(i.e. when the trap condition is established).
When the Save Image Mode is set to Trap, processing is not interrupted even
if the trap condition is established.
However, if Overwrite is set to No, processing is interrupted at the point when
the limit for the number of images that can be saved is exceeded and the trap
conditions are established, and an error message is displayed on the screen.
Refer to 13.4 Judgment for details regarding the Trap function.
− Limit Condition (Lim. Cond.)
Sets the upper and lower limit values for the last three formulas of the numerical
calculation results(CA30, CA31, CA32), and whenever one of them exceeds
that range, the image is saved.
5 − 10
OCR Type A230
Advertisement
