Advertisement
Inspection Results and Output
13.3
Numerical Calculation
To Delete a Programme
Procedure:
1.
Select the register No. of the programme you want to delete.
2.
Use the cursors to move the highlight cursor to the "=" location, then press B
to delete the programme.
CA01=GE02011−GE01011
Setting and Canceling Output Control
Restrict output of numerical calculation registers that you do not want to output over the
serial or parallel interface.
Procedure:
1.
Select the register No. of the programme you do not want to output.
A:OutpContr.
2.
Use the cursor lever to move the highlight cursor to any location other than "=",
then press A. An "X" mark is displayed at the left of the register No.
XCA01=GE02011−GE01011
3.
If a register has been specified for output control, but you want to change the
setting so that it can be output, move the highlight cursor to any location other
than "=", then press A again and the "X" mark disappears, enabling numerical
calculation output for that programme.
CA01=GE02011−GE01011
Even if a formula is set, and the Serial Output settings in the Environment menu are set
to output a numerical calculation, the results of numerical calculation registers that have
an "x" is displayed in front of the register are not output.
Setting and Canceling Specific Substitution
Procedure:
1.
Align the cursor with the "=" position.
CA01=GE02011−GE01011
2.
Press A to change the "=" to "!", and specific substitution is set.
CA01!GE02011−GE01011
3.
To cancel specific substitution, press A again and "!" changes back to "=".
13 − 16
B:Delete
OCR Type A230
Advertisement
