Advertisement
OCR Type A230
(2) When the position adjusters have been nested, each
No.2 is adjusted in accordance with the amount of movement
of No.1, and No.3 is adjusted in accordance with the amount of
movement of No.2. By setting the position adjustments in this
way, it is possible to have a position adjustment checker
based on the results of an earlier position adjustment checker.
(multiple position adjustment)
Note
If you want to adjust position adjustments (i.e. to nest position
adjustments), ensure that the later adjuster specifies a group
number lower than its own number.
adjusting the result of the previous adjuster:
Each adjuster works on the result of the position
adjustment checker specified by the group number, so
that all the edges required are successfully detected.
Slightly misaligned for greater clarity
Misalignment
Position adjustment No.1
↑ Follow−up
Position adjustment No.2
↑ Follow−up
Position adjustment No.3
Position and Rotation Adjustment
6.4 Position Adjustment Groups
Adjustment for Group No.1
Adjustment for Group No.2
6 − 35
Advertisement
