Advertisement
Communications (Serial and Parallel)
16.7
Char. Verif. − Character (pattern) Re−registration
16.7.4
Character re−registration procedure and notes
Re−registration using parallel input
Procedure:
1.
Specify the number of the Character Verification checker to perform
re−registration.
2.
Input the re−registration input signal (IN6) for the first time (the READY signal
will go off).
3.
If a position/rotation adjustment group has been specified, the specified
Position/Rotation Adjustment checker will scan and adjust the Character
Verification checker.
Note
If the Position/Rotation Adjustment checker produces a NG result
(due to being unable to detect an edge etc.), the re−registration
processing is cancelled, and the ERROR signal goes on.
4.
If a position/rotation adjustment group has been specified:
Segmentation is performed at the adjusted position, and the checker pattern
and segmented character (pattern) are displayed.
If the position/rotation adjustment group is "0":
Character (pattern) segmentation is done at the position set when the area
was created, and the checker pattern and segmented character (pattern) are
displayed.
Note
If the Character Verification checker could not perform character
(pattern) segmentation, the re−registration processing is
cancelled, and the ERROR signal goes on.
5.
Input the re−registration input signal (IN6) for the second time.
6.
Re−registration will be performed and the READY signal will go on when it is
complete.
16 − 38
OCR Type A230
Advertisement
