Set The Transfer Function On The Transmitter By Cometer; Set The Transfer Function On The Transmitter By Hht; Set The Transfer Function On The Transmitter By Pc; Set The Transfer Function On The Meters - ABB 2600T Pressure Transmitter Series User Manual

364xS User's Manual 36
In case the Square root transfer function has been selected
Navigate the Digital LCD Integral Display menu, select Device Config > Transfer Function > Linearization
Point, and the percentage input value up to the Transfer function is anyway linear may be available.
Select the desired value and confirm.
In case a Flow transfer function has been selected
Navigate the Digital LCD Integral Display menu, select Device Config > Transfer Function > Low Flow Cut
Off, and the input value up to the Transfer function is anyway zero may be available.
Select the desired value and confirm.
In case one of the polynomial transfer function has been selected
The existing polynomial coefficients in the transmitter will be used. The coefficients can be set or modified
only by HHT and PC.

Set the Transfer function on the transmitter by CoMeter

The Transfer function setting by CoMeter is available with the 695 Field Indicator. Please refer to the device
manual for the appropriate operations.

Set the Transfer function on the transmitter by HHT

The Transfer function setting by Hand Held Terminal is available. Please refer to the device manual for the
appropriate operations.

Set the Transfer function on the transmitter by PC

The Transfer function setting by PC is available using dedicated Software. ABB can provide the references
and the Software. Please refer to the Software instructions for the appropriate operations.

Set the Transfer function on the Meters

The Transfer function on the Meters works only on the meters reading and not on the trasmitter output.

Set the Transfer function on the Digital LCD Integral Display

On the Digital LCD Integral Display only the transfer function can be selected. The existing Square root
parameter or polynomial coefficients in the transmitter will be used. The coefficients can be set or modified
only by HHT and PC.
Navigate the Digital LCD Integral Display menu, select Display > Display Settings > Display Transfer
Function, and the Transfer functions will be available.
Select the desired value and confirm.
Digital LCD Integral Display Keys sequence to set the Transfer Function on the Display: 3 – 7 – 4 – Edit

Set the Transfer function on the Digital LCD Integral Display by HHT

The Digital LCD Integral Display Transfer function setting by Hand Held Terminal is available. Please refer to
the device manual for the right operations.

Set the Transfer function on the Digital LCD Integral Display by PC

The Digital LCD Integral Display Transfer function setting by PC is available using dedicated Software. ABB
can provide the references and the Software. Please refer to the Software instructions for the right
operations.

Signal simulation (fixed output current)

During the start up or for diagnostic purposes, it is useful to have the possibility to generate some reference
signal to be sent to the receiver (Controller, DCS, recorder, PLC, etc.). This is possible directly by means of
the transmitter, without disconnect its electrical connection and without a 4-20 mA generator or a pressure
generator.
Configuration