Diagnostics On The Cometer; Hart Version Diagnostics On The Hht; Hart Version Diagnostics On Thepc - ABB 2600T Pressure Transmitter Series User Manual

Hide thumbs

Table Of Contents

Table of Contents

364xS User's Manual

Corrective actions: Check the ambient temperature. If it is within the limits see 1, 2, 3.

Consistency Check

The secondary electronic and the primary electronics have not been working together before.

Corrective actions: If this message appears during a replacement, please follow the replacement instruction

in the relevant section of this manual. If the error persists see 1, 2, 3 or 4

Config. Error

Bad configuration of range and/or transfer function.

Corrective actions: Please follow the setting configuration instruction in the relevant section of the this

manual. If the error persists see 1, 2, 3 or 4

Sensor Elec. Fail

There are internal inconsistencies in the memory of the primary electronic. This test is performed at the start

up.

Corrective actions: 1, 2, 4

Tot. Config Error

The configuration of the totalizer is not correct

Corrective actions: Please follow the totalizer instruction in the relevant section of the this manual. If the

error persists see 1, 2, 3 or 4

Common corrective actions:

Switch the transmitter off and on to verify if the message appears again

With the HART command 48 it is possible to obtain additional information on the failed component

If the message persists the secondary electronic is suspected to have a failure. If the output is in a

failure status (high or low) the fault is severe and it is necessary to substitute the secondary electronic.

Otherwise the failure is minor, the signal is still valid but with a lower accuracy. The secondary

electronic can be substituted when convenient.

If the message persists, the primary electronic could be damaged. If the output is in a failure status

(high or low) the fault is severe and it is necessary to substitute the transducer. Otherwise the failure is

minor, the signal is still valid but with a lower accuracy. The transducer can be substituted when

convenient.

Check the process and ambient conditions (e.g.: pressure, process temperature, ambient temperature

static pressure, etc.) against the sensor and electronics limits. If the conditions are close or outside the

limits, these improper instrument utilization can have seriously compromised the instrument

functionality. If the conditions are well inside the limits see the corrective actions of point 4 or 3.