Clear-Com ECLIPSE MEDIAN MATRIX Instruction Manual page 99

Vitec Group Communications
Eclipse Median Instruction Manual
card's microprocessor. The card and all connected panels and
interfaces momentarily stop their current activity and restart. The reset
button must be pressed for more than two seconds to take effect.
If the entire system is operating except for one port card, or one or
more panels connected to the card, press the reset button for that card
only.
Note: This button is slightly recessed from the front panel to
prevent it from being accidentally pressed. You need a tool,
such as a bent paper clip, to press this button.
CPU Card Reset Button
When you reset the CPU card by pressing its reset button, the card's
non-volatile RAM reloads all configuration information to the card's
microprocessor. Resetting the card clears any corruption of data in the
card's microprocessor. The card momentarily stops its current activity
and restarts.The same system configuration that was active before you
reset the card will be active after you reset it.
Note: The reset button is slightly recessed from the front panel to
prevent it from being accidentally pressed. You need a tool,
such as a bent paper clip, to press this button.
CPU Card Full Reset Button
When you press and hold the full-reset button and simultaneously
press the reset button, the system performs a cold restart. All cards in
the matrix reset regardless of any system preferences in the program
software and the non-volatile memory is cleared. All audio devices
connected to the cards, such as panels and interfaces, reset as well.
When the cards and connected audio devices reset, they momentarily
stop their current activity and restart. During this process configuration
information is downloaded to the port cards and remote audio devices
from the CPU card's microprocessor.
The same system configuration that was active before you reset the
card will be active after you reset it. You must press the button for more
than two seconds for the reset to take effect.
Note: Under normal operating conditions it is not necessary to
perform a full reset. Technical personnel might perform a
full restart if they believe that the CPU card is operating
incorrectly as a result of corruption of the
microproccessor's internal data or instruction sequence.
6 - 7