Installing Rear Rj-45 Connector Panels In The Field; Installing Cpu Cards - Clear-Com ECLIPSE MEDIAN MATRIX Instruction Manual

Frame and circuit cards
Hide thumbs Also See for ECLIPSE MEDIAN MATRIX:
Table of Contents

Advertisement

Vitec Group Communications
Eclipse Median Instruction Manual
INSTALLING REAR RJ-45 CONNECTOR
PANELS IN THE FIELD
Installing or removing a rear panel from the matrix is a simple
procedure, allowing you to easily customize the matrix to your
operating environment.
To add a rear panel to the matrix
1. Remove the desired blank rear panel by loosening the screws and
pulling the panel out. The screws are attached and cannot be
removed.
2. Install the new rear panel by sliding the card into the card's guides at
the top and bottom of the Eclipse Median chassis.
3. Tighten all of the screws on the rear panel.
To remove a rear panel from the matrix
1. Detach any remote devices connected to the rear panel's
connectors.
2. Loosen the screws that hold the rear panel to the matrix. The screws
are attached and will not fall off.
3. Remove the rear panel by pulling the panel out.

INSTALLING CPU CARDS

The CPU card's components include CMOS chips which are sensitive
to static electricity. Before touching the CPU card with your hands,
touch a grounded metal object, such as any unpainted surface on the
matrix, to dissipate static electricity. While handling the CPU card, be
careful not to bend any of the card's connector pins or component
leads.
Before operating the CPU card, you must reconnect the card's battery.
The CPU card is shipped with a disconnected battery to preserve
battery life. For instructions on reconnecting the battery, see
"Re-Connecting the CPU Card's Backup Battery" on page 5-1.
The DIP switches on the CPU card should be checked before
installation to ensure they are correctly configured. In particular SW3
switch 2 is only used to put the MVX card into maintenance mode and
must be set to OFF for normal operation. The CPU card switch
settings for normal operation are shown in Figure 5-2.
Note: If the Maintenance mode switch is set to the ON position
system performance may be adversely affected.
5 - 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECLIPSE MEDIAN MATRIX and is the answer not in the manual?

Table of Contents