Figure 5-14 Non-Isolated Connection To Eclipse Median Gpi Connector - Clear-Com ECLIPSE MEDIAN MATRIX Instruction Manual

Frame and circuit cards
Hide thumbs Also See for ECLIPSE MEDIAN MATRIX:
Table of Contents

Advertisement

5 - 2 0
+3V3
R29 1.5K
EXTERNAL INPUT 1
R30
EXTERNAL INPUT 2
Figure 5-14: Non-Isolated Connection to Eclipse Median GPI Connec-
To cause an input to detect an active signal, you must send current
from the relevant input pin.
The external device should draw no current to cause an inactive input
and at least 5 mA to cause an active input. The opto-isolator drive line
contains a 1.5 kOhm resistor to limit the current through the
opto-isolator. You can therefore connect the input pins directly to a
ground pin to cause an active input.
The voltage level at the external input pin should not be allowed to go
below ground or above +6 V with respect to ground.
+3V3
U
1
8
2
7
3
6
1.5K
4
5
MOCD207-M
tor
Eclipse Median Instruction Manual
+3V3
R
R
33K2
33K2
INPUT 1
INPUT 2
Vitec Group Communications

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECLIPSE MEDIAN MATRIX and is the answer not in the manual?

Table of Contents