Requirements - Universal Robots e Series Installation Manual

Hide thumbs Also See for e Series:
Table of Contents

Advertisement

3.3. Requirements

The serial number of the control box must be newer than 2020020161. The hardware revision of the
safety control board electronics is Rev.F2.
NOTICE
Installing an e-Series Injection Molding Machine Interface (IMMI) in a control box
with a serial number lower than 2020020161 can result in damage to equipment or
property.
• Verify your control box serial number before installing the IMMI module.
• You can verify your safety control board if necessary.
Control box
The control box serial number is located on the underside of the control box bracket. The following
illustration shows the label and the control box serial number.
e-Series Injection Molding Machine
Interface (IMMI)
8
3. Product description
Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the e Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents