Introduction; About This Document; What's In The Box; Company Details - Universal Robots e Series Installation Manual

1. Introduction
1. Introduction

1.1. About this document

This guide describes how to install a Universal Robots Injection Molding Machine Interface (IMMI)
module on a Universal Robots e-Series control box and how to configure the Injection Molding
Machine Interface (IMMI) software, to interface with an Injection Molding Machine (IMM).

1.2. What's in the box

The box contains the following parts:
• IMMI module
• Cables:
• EUROMAP 67 / SPI AN-146
• Ribbon cable
• Ground (GND) wire:
• M6 nut
• M6 washer
• Universal Robots EUROMAP 67 bypass plug
• This document

1.3. Company Details

Universal Robots A/S
Energivej 25, 5260 Odense S, Denmark
+45 89 93 89 89
https://www.universal-robots.com
Installation Guide
e-Series Injection Molding Machine
1
Interface (IMMI)