Using The Power Calibration Tab - Keysight Technologies S9100A Startup Manual

7. 3. 3 Using the Power Calibration Tab

This section describes how the Power Calibration tab is used to provide an accurate
power level at each mmWave Transceiver input and output port.
Power Calibrations
If the standard configuration is:
S9100A Option RH1 5G Multi-Band Vector Transceiver
If the standard configuration is:
S9100A Option 007 mmWave Transceiver with High IF
If the standard configuration is:
S9100A Option 022 mmWave Transceiver with High IF and Blocker
S9100A 5G Multi-Band Vector Transceiver, Startup Guide
The calibrations to be run depend on the standard
configuration being calibrated: S9100A-RH1, S9100A-007,
or S9100A-022
All alignments must be run before Power Calibrations.
(See Using X-Apps to Perform
a.
Calibration 1 of 2: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2 on page 76
b.
Calibration 2 of 2: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1 on page 78
a.
Calibration 1 of 2: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2 on page 80
b.
Calibration 2 of 2: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1 on page 82
a.
Calibration 1 of 2: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2 on page 84
b.
Calibration 2 of 2: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1 on page 87
7 Run Power Calibration
Alignments on page 74.)
75