Calibration Equipment Required - Keysight Technologies S9100A Startup Manual

7. 2 Calibration Equipment Required

S9100A 5G Multi-Band Vector Transceiver, Startup Guide
Keysight Equipment
U8487A 10 MHz to 50 GHz USB Thermocouple
Power Sensor or equivalent
(Alternates)
N8487A 50 MHz to 50 GHz Thermocouple Power
Sensor with: N1913A or N1914A.
8121-3222 cable, 2.4 mm (m) to 2.4 mm (m),
152.4 mm (6.0 in) or equivalent
One of these loop-back cables are included with
each S9100A standard configuration.
11900B adapter, 2.4 mm (f) to 2.4 mm (f)
or equivalent
11903B adapter, 2.4 mm (f) to Type-N (f)
or equivalent
(Alternate)
1250-1472 adapter, Type-N (f) to Type-N (f) can
also be used, but with lower accuracy. If an EPM
or P-Series power meter is used, this adapter can
be used on the power meter for sensor calibration.
11903D adapter, 2.4 mm (f) to Type-N (m)
or equivalent
8121-3144 cable, Type-N (m) to Type-N (m),
500 mm (19.7 in) or equivalent
1250-1472 adapter, Type-N (f) to Type-N (f)
or equivalent
7 Run Power Calibration
Purpose
Power Sensor with built-in calibration.
This loop-back cable can be connected from
RF Tx/Rx 1 to RF Tx/Rx 2 (source to receiver)
on the M1740A mmWave Transceiver only
when testing for operation;
during normal use, this loop-back cable is
removed.
This adapter is used to connect the
U8487A Power Sensor or equivalent to the
end of the loop-back cable (described above)
that is used during Cable signal path cal-
ibration. It can also be used to connect two
2.4 mm (m) to (m) cables during
Receiver (Rx) signal path calibration.
This adapter is used to connect two
Type-N (m) to (m) cables during
Receiver calibration.
This adapter is used to connect a
2.4 mm (m) to Type-N (f) ports, such as DUT
IF and RF ports.
This cable is used to connect source to
receiver during Receiver calibration.
This adapter is used to connect two
Type-N (m) to (m) cables during
Cable calibration.
61