7 Run Power Calibration
7. 4. 3 Using the Power Calibration Tab
This section describes how the Power Calibration tab is used to provide an accurate
power level at each mmWave Transceiver input and output port.
Power Calibrations
If the standard configuration being calibrated is an:
S9101A-TR1 5G Multi-Band Vector Transceiver, perform:
If the standard configuration being calibrated is an:
S9101A-BK1 5G Multi-Band Vector Transceiver TR1 with Blocker, perform:
If the standard configuration being calibrated is an:
S9101A-TR2 5G Multi-Band Vector Transceiver, perform:
68
The calibrations to be run depend on the standard
configuration being calibrated: S9101A-TR1, S9101A-BK1,
or S9101A-TR2
All alignments must be run before Power Calibrations.
(See
Using X-Apps to Perform
a.
Calibration 1 of 2: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2 on page 69
b.
Calibration 2 of 2: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1 on page 72
a.
Calibration 1 of 2: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2 on page 75
b.
Calibration 2 of 2: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1 on page 78
a.
Calibration 1 of 4: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2,
Transceiver 1 on page 81
b.
Calibration 2 of 4: Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1,
Transceiver 1 on page 84
c.
Calibration 3 of 4: Power from RRH 1 RFHD 1 -> RRH 1 RFHD 2,
Transceiver 2 on page 87
d.
Calibration 4 of 4 Power from RRH 1 RFHD 2 -> RRH 1 RFHD 1,
Transceiver 2 on page 90
Alignments on page 67.)
S9101A 5G Multi-Band Vector Transceiver, Startup Guide