Run S910Xa System Calibration Software - Keysight Technologies S9100A Startup Manual

5g multi-band vector transceiver

Table of Contents

7 Run Power Calibration

7. 3 Run S910xA System Calibration Software

Once S910xA System Calibration has been installed, a shortcut can be found

in the Windows Start menu. S910xA System Calibration can also be started by

navigating to the installation folder:

Calibration

If it is not already running, start S910xA System Calibration:

The following tabs are available in S910xA System Calibration software:

and running

S9100A System Calibration.exe

S910xA System Calibration can be started as follows:

Select the Start menu (lower-left corner icon)

> Scroll down to "K" applications

> Select the Keysight S910xA drop-down arrow

> Scroll down the list and select S910xA System Calibration

Using the Equipment Tab on page 65

to enter VISA Address and hislip socket number "Connection Strings"

for all equipment used during Calibration.

Using the Power Calibration Tab on page 75

to provide an accurate power level at each mmWave Transceiver input

and output port.

C:\Program Files\Keysight\S9100A\System

S9100A 5G Multi-Band Vector Transceiver, Startup Guide

Table of Contents