Source Subsystem - Keysight Technologies S9100A Startup Manual

8. 0. 8 Source Subsystem

Source Subsystem commands are only available when the S91XXBLK-1FP license is
present on the system and all the required hardware is present.
In conformance test systems, there are two sources:
primary source
is the "intended" signal of interest (wanted signal)
secondary source
is the "blocking" signal that could possibly interfere, jam, or block the signal of
interest
[:SOURce]:CONFigure:ADDRress PRIMary|SECondary,{hislip number}
[:SOURce]:CONFigure:ADDRress? PRIMary|SECondary
The source configure address command exists for maintenance or custom
configurations.
The
hislip
be changed as they are inferred from the hardware configuration.
[:SOURce]:CONFigure[:STATe] 0|1|ON|OFF
[:SOURce]:CONFigure[:STATe]?
The source configure state command allows for enabling or disabling
a conformance test.
As the configuration is enabled, the conformance properties are set on the primary
and secondary M941x sources.
Default 0 (Off)
[:SOURce]:CONFigure:PORT[:OUTPut]
RRH1RFHD1|RRH1RFHD2|IFIO1|IFIO2|RFOut
[:SOURce]:CONFigure:PORT[:OUTPut]?
The source configure port output command sets the port to be used when outputting
the combined signal (of primary and secondary M941x sources) for conformance
testing. Ports are restricted by available hardware in the system.
Default RRH1RFHD1
S9100A 5G Multi-Band Vector Transceiver, Startup Guide
number of the primary and secondary M941x sources should not need to
8 S910xA SCPI Programming Commands
97