System Subsystem; Status Subsystem; Display Subsystem - Keysight Technologies S9100A Startup Manual

8 S910xA SCPI Programming Commands

8. 0. 2 System Subsystem

:SYSTem:ERRor[:NEXT]?
The system error query returns the next error from the SCPI error queue.
If there are no error messages in the SCPI error queue,
the system error query returns the following:
If there are more than one error message in the SCPI error queue,
the system error query must be sent for each message.
:SYSTem:OPTion?
The system option query returns a comma separated list of options for the S910xA
system.

8. 0. 3 Status Subsystem

:STATus:OPERation:ROSCillator?
The status operation query returns the status bit for the register of the reference.
If the reference module is unlocked, this query returns a 1.
If the reference module is locked, this query returns a 0.

8. 0. 4 Display Subsystem

:DISPlay:ENABle 0|1|OFF|ON
:DISPlay:ENABle?
The display enable command enables or disables the display of conformance
property values for debugging purposes that are set through SCPI commands. The
property information is displayed in the S910x Service Manager window.
Leaving this enabled has a performance penalty due to the overhead of writing the
information to the user interface as the properties are set on hardware.
Default OFF (0)
94
+0,"No Error"
S9100A 5G Multi-Band Vector Transceiver, Startup Guide