Table of Contents
Advertisement
Nova230i Outdoor 2x500 mW eNodeB Installation Guide
3.7.4.3 Static Routing
When using static routing, go to Network > Static Routing. The Network > Static Routing landing
page has two main sections, Static Routing Config and Validated Route List (Figure 3-19). The
configured static route information is displayed under Static Routing Config. To edit a static route
in the list, click on the Edit
click the Add
icon. Fill in the information and click OK. Field descriptions are in Table 3-3.
Figure 3-19: Static Routing
NOTE: For each field description, refer to the
CAT6/CAT15 Configuration
Table 3-3: Static Routing
Field Name
Index
Enable
Destination Network
Netmask
3.7.5 Configure the Management Server
In the BTS Setting > Management Server window, you will enter the network management service
(NMS) information (Figure 3-20). When using the Baicells CloudCore to manage the network, in
the http:// field, enter the following URL address and port number:
http://baiomc.cloudapp.net:8443/smallcell/AcsService
If you are using Local OMC or another NMS, enter its server address and port number. Refer to
the field descriptions in Table 3-4.
icon, enter the information, and click OK. To add a static route,
Guide.
Description
Auto-generated router index number
Enable/Disable the static route
The destination IP address
The destination subnet mask
30
CAT4 CPE Configuration Guide
and
Advertisement
Table of Contents
