Separation Of The Two Parts Of The Machine - Stiga 2021 Edition PARK 320 P Workshop Manual

WORKSHOP MANUAL
4. Remove the tightener arm (25).
● Reassembly
Perform the steps described above in reverse order, taking care of:
24
22
21

3.2.2 Separation of the two parts of the machine

WARNING!
a particularly demanding operation, which must be performed by implementing all the
measures to prevent any event that could put the safety of the operator at risk.
NOTEThis intervention is required only for the replacement of the bearings of the articulated joint,
in the face of a noticeable backlash and consequent possibility of reciprocal movement in the cou-
pling between the two parts of the machine.
PARK
25
23
The operation of separating the front and rear parts of the machine is
Chapter
3 - CASINGS AND FRAME
4
– correctly reposition all the washers and
spacers previously removed, according to
the sequence shown in the drawing;
– fit the centering spacer with the protrud-
ing part correctly inserted in the hole of the
tightener arm
EDITION
2020
25
– Tighten the central
21
screw (21) with a
torque wrench set to
35-50 Nm.
PAGE
38 /
124