Stiga 2021 Edition PARK 320 P Workshop Manual page 39

WORKSHOP MANUAL
PARK
1. Remove the front casing of the belts
2. Remove the rear belt casings
3. Completely loosen the steering chain
4. Disconnect the throttle
the engine side , taking care of connecting the two terminals to a cable
or a cable pulling probe in order to facilitate the subsequent reset.
5. Remove the clamps securing the cable sheaths and hydraulic pipes
where the articulated joint is.
6. ▶▶ Park 4WD : Empty the oil circuit
[ 7.2.2] at point 6.
7. Remove the pulleys of the articulated joint.
8. Stabilize the rear part of the machine which bears the greatest weight and is therefore less
manageable.
WARNING!
separating.
1
9. Unscrew the screw (1) and remove the inter-
nal spacer (2) which holds the rear frame (3)
together with the front part of the machine by
means of the fork (4).
10. Move the front part as needed and stabilize it.
When assembling, perform the steps described
above in reverse order, paying particular attention
to restore all the fastening clamps of the wiring
sheaths and hydraulic pipes.
3 - CASINGS AND FRAME
[
[ 3.1.3].
[
[ 5.1.5] and choke
[
Ensure stability before
Chapter
3.1.2].
4.2.1]. from 1 to 3
[ 5.1.6] cables from
8.3.2] and disconnect the front transmission tubes
[ 3.2.1].
1
2
3
4
EDITION PAGE
2020 39 /
124