WORKSHOP MANUAL
PARK
4. Place a container under the front transmission
unit and drain all the oil by unscrewing the two
drain plugs (6) and (7).
5. Let all the oil flow into the container.
6. Prepare the amount of oil necessary for filling
the tank of the loading equipment
7. When the oil has stopped dripping, screw the
filter cap (3) and all the caps previously un-
screwed (4), (5), (6), (7) again, always taking
care of replacing the caps if the seals are dam-
aged.
8. Connect the hose of the loading equipment (8)
to the quick coupling (9), mounted on the front
unit (for 4WD) or on the rear (2WD).
9. Start the equipment, load the predetermined
amount of oil and finally disconnect the hose
(8) from the quick coupling (9).
10. Check that the oil level in the tank (2) has
reached the correct level.
Chapter
8 - HYDRAULIC SYSTEM
▶▶ 4WD
[
8.1.4].
▶▶ 2WD
2
EDITION
2020
6
7
8
9
9
8
PAGE
96 /
124